Installing Window Clings

Pre-Installation:

458727_low

  1. Surface must be thoroughly cleaned from dust, grease or any contamination which could affect the adhesion of the material
  2. Use mild soap and water to clean the glass
  3. Do not use cleaners with solvents such as Windex
  4. Surface temperature must be above 40 degrees F and below 90 degrees F
  5. In cold weather apply window cling in late afternoon after the windows have warmed up
  6. In Hot weather apply window cling in the early morning while the glass is still cool

Installation Instructions:

  1. Lift the upper edge of the liner away from the vinyl and fold back approximately 3-6 inches
  2. Carefully position the film so that it is properly aligned on all sides, then press the upper corners in place using light pressure
  3. Using your hand or squeegee, lightly press the film in place
  4. Working from the top of the graphic to the bottom, continue by peeling away more of the liner and applying light pressure to the film
  5. Using a utility knife, carefully trim away any un-needed portion of the graphics
  6. Finally, squeegee the film from the center and work outward in all directions

Leave a Comment





twenty − seventeen =